Tips and Tricks by ACTIVE Vapor Devices

Getting the most from your ACTIVE Pulse™ all-in-ones, cartridges, and batteries

You’ve got great taste

Your ACTIVE™ all-in-ones, cartridges, and batteries were designed for reliability. They are also engineered with No-Burn Technology™, so you get to enjoy the true-to-strain flavor of your extract.

By keeping the power input consistent, ACTIVE Pulse™ prevents heat spikes and maintains a consistent temperature. This maximizes flavor and cannabinoid retention throughout the lifetime of your device.

BATTERY TECHNOLOGY

ACTIVE PULSE™

ACTIVE™ batteries utilize ACTIVE Pulse™ to stabilize the temperature by sending short intermittent power pulses to the cartridge. Overheating is avoided and you get to experience the full flavor profile.

TIPS AND TRICKS

ACTIVE™ Vape Troubleshooting

How to clear a clog in an ACTIVE™ vape

Option 1

Pre-heating: ACTIVE all-in-ones and batteries are engineered with a special pre-heat function. On the bottom of your battery or all-in-one, you’ll see a small airhole. Blow once or twice into the hole to pre-heat thicker extracts before starting your session. Then vape as usual!

This technique doubles up to help clear the airway should you experience any clogging.

Option 2

Alternate heating technique: Warm your cartridge in your hand or place it near a heat source. BUT only for a few seconds! Once you see the oil thin out, remove the heat. Overheating cartridges can make things worse. Be gentle with the amount of heat!

Still clogged? Or has your cartridge stopped working?

Cleaning your ACTIVE™ battery and cartridge

Using a cotton swab lightly dampened with 70%-90% isopropyl or ethyl alcohol, carefully clean around the cartridge and battery threads and contact point.

Cartridge Care Best Practices

Do not leave carts in your car or in direct sunlight. It's bad for the oil and the cart. Temperature changes can cause clogs and leaks
Store your cartridge upright to avoid leaks
Keep your cartridge at room temperature to avoid clogs and leaks
Don’t drop your cartridge, all-in-one, or battery. It hurts their feelings
Never over-tighten your cart when screwing into a battery
Use a protective case or cover to prevent damage or debris from entering the mouthpiece
Use batteries made for cannabis cartridges. 510 thread or a magnetic adapter style is best
Be careful with E-Cig style box mods as they could burn out your coil

How do I charge my ACTIVE™ battery?

Saving our planet

To reduce waste, ACTIVE™ is phasing out the charge cables we used to include with our batteries. Most of us have spare micro-USB and USB-C chargers we use for our other electronic devices. To charge your ACTIVE™ battery or all-in-one, connect the USB charge port located at the bottom of the battery to a power source, and start charging.

Warning: Do not use power chargers that output more than 5 volts. This may damage the battery

Pro Vape Tips

We vape. A lot. Strictly for testing purposes, of course

Low — **Elevation:** You should follow all laws concerning transportation of filled cartridges. Drastic elevation changes, such as those that occur while flying, may disrupt the pressure-seal balance of a filled cartridge, causing a leak. If you do fly, keep your cart upside down so the oil does not get pushed through the atomizer.

Medium — **Storage:** Try to store your cartridge at a moderate temperature. Avoid areas below 40°F and above 85°F for optimal performance. Extreme cold can cause clogging and spitting. Excessive heat can result in leaks.

High — **Session Length:** Clearing your entire cart in one sitting, though tempting, may not be the best idea. Green-outs aside, if you chain vape, it may impact the flavor. Let your cartridge cool after a few minutes of seshing before you continue

What do all those lights and vibrations mean

Green light. Red light. Pulsing light. Vibrations.

They all mean something, depending on which device you have.

ACTIVE™ Batteries

ACTIVE™ Seed Battery haptic vibration

Active use indication: Vibration 〰️
Charging Indicator: Blinking red light 🔴
Fully Charged: Solid green light 🟢
10-second draw indicator: Vibration stops
Short Circuit: 3 long vibrations 〰️ x3
Connection Error: 2 quick vibrations 〰️ x2
Over use Protection: Device deactivates after a 10 second draw activation.
Device resets after draw is finished
Low battery: 5 short vibration 〰️ x5
Charging Port: Micro-USB