Please follow these directions for the following products to avoid leaks, clogs, and other issues. Failure to adhere to these practices may invalidate your warranty.
Ombu Air All-In-One Filling Directions
Recommended Needle Size | Ideal Fill Temperature | Capping Time |
|---|---|---|
16-20ga | 90°F/32°C (thinner oils) – 135°F/57°C (thicker oils) | 8-10 mins (depending on viscosity) |
Do not overfill your devices. Fill to the maximum level indicated below.
Insert a blunt tip 16 to 20 gauge needle into center filling hole.
Caution: Be aware of filling needle depth, touching the ceramic core may cause damage.
The recommended oil temperature range at time of filling is 90°F-135°F. The ideal fill temperature will allow for filling and capping before the oil saturates the atomizer.
Oversaturation from hot filling, thin oils, and/or slow capping will cause flooding, clogging and leaking.
Do not overfill your devices! Fill to a maximum of 1.05mL. Overfilling may cause seal bulging and will force fluid through the atomizer.
Wait to cap, between 8-10 minutes. Thicker oils may need longer to saturate. The Ombu Air has a large core that needs time to saturate for best performance.
Ombu Air All-In-One Capping Directions
Capping time | Capping method | Minimum capping force | Maximum capping force |
|---|---|---|---|
8-10 mins (depending on viscosity) | By hand or arbor press | 15-17lbs (7-8kg) | 130lbs (59kg) |
Make sure to wait 8-10 minutes before capping to allow for saturation.

Make sure the mouthpiece is properly aligned and straight. Press the mouthpiece down vertically (not at an angle) using even pressure, until you hear a click.

You can seat the mouthpiece by hand, but a light-duty arbor press and jig are recommended. Do not use a hammer or mallet!

Pressing at an angle can lead to damage, improper sealing, leakage, and cracking of the device.
If too much pressure (over 130lbs) is applied during capping, you can damage the device and the battery. Check the pressure carefully.
You cannot remove the mouthpiece once it’s fully seated without damaging the device or the mouthpiece.
Let your device stand for a minimum of 24 hours before using to avoid dry hits that can impact flavor. During this time, the oil is priming the atomizer.







































